Extremly simple eletrical question.
#1
Contributing Member
Thread Starter
Extremly simple eletrical question.
Ok this is frigging ridiculous. Ive wired lights, accessories, have taken 2 electrical engineering courses, and i can't figure what the hell is going on.
Im trying to wire up my blinkers on my ARB bumper... DEERRR....
Ok. I get 12V to bulb mounting surfaces... Great... COOL... easy.
Put bulb in, test, 0V.... No lighting of bulb.
Ok... bulb must be burnt... Nope, tested fine with ohm-meter and it lights up when connected to 12v battery.
WHAT THE HELL is causing the reading to drop to 0 volts with bulb in place!?!?!?
Im trying to wire up my blinkers on my ARB bumper... DEERRR....
Ok. I get 12V to bulb mounting surfaces... Great... COOL... easy.
Put bulb in, test, 0V.... No lighting of bulb.
Ok... bulb must be burnt... Nope, tested fine with ohm-meter and it lights up when connected to 12v battery.
WHAT THE HELL is causing the reading to drop to 0 volts with bulb in place!?!?!?
#3
Contributing Member
Thread Starter
I got them working...
I integrated a harness so I could easily disconnect the lamps to take off the bumper...
They worked fine with my fog lamps... Apparently they won't work with turn signals. I donno wtf was going on.
So nevermind
I integrated a harness so I could easily disconnect the lamps to take off the bumper...
They worked fine with my fog lamps... Apparently they won't work with turn signals. I donno wtf was going on.
So nevermind
Thread
Thread Starter
Forum
Replies
Last Post
kawazx636
The Classifieds GraveYard
34
10-06-2021 03:03 PM
live4soccer7
84-85 Trucks & 4Runners
3
05-11-2016 06:52 PM
punks_is_4x4
86-95 Trucks & 4Runners
1
02-26-2016 04:29 PM