Engine's OUT (hourly update continues)
#1
Registered User
Thread Starter
Engine's OUT (hourly update continues)
Well, I got the engine out just a few minutes ago. I employed my uncle since he was willing to help. It sure does go faster with another man on the team. I pulled it out, with the torque converter still attached. Luckily, didn't loose much fluid at all. Luckily I was able to break all 1 one of the torque converter's bolts loose. The only tough one was the one up at the top where the exhaust crossover pipe is. If you're wondering why I'm not turning the motor over so I can access them, it's because there's a hole on each side of the block, where something seemed to have gone wrong, and left the engine locked up tight! I'll take some pictures in the morning. Hopefully by tomorrow at this time the new engine will be in the truck. I'm not optimistic enough to say it will be running, but at least it should be in there. I'm happy with that!
Thread
Thread Starter
Forum
Replies
Last Post
jasonty
Pre 84 Trucks (Build-Up Section)
41
12-23-2018 01:00 PM
FS[SouthEast]: Mercury Villager Fan & DCC Fan Controller
coryc85
Misc Stuff (Vehicle Related)
6
09-09-2015 06:24 AM