Shiner5

I bought a used Draw Tite hitch and need help with the install. I searched and could not find and installation instructions. It is pretty straight forward except I don't know where to bolt it.

If anyone has a Draw Tite on the vehicle, could you please shoot a couple of digital pics and e-mail them to me so I can see how it is done.

dcaldwell@stanleyworks.com

Thank you for your time and help.

Darrell

Marc M

Were there any other parts that you got with the hitch, ie bolts and/or brackets ???

Marc

yamarocket630

I just intstalled mine a few weeks ago, if I can find the instructions, I'll scan them and post a link.

Shiner5

There were only two bolts about 2 inches long. That's it. Help.

Shiner5

That would be huge. Thanks.

yamarocket630

I can't find the instructions, but I remember them being rather useless anyway. The hitch comes with 6 bolts, nuts, washers, and some steel plates. It uses the 2 bolts on each side of the frame that the rear bumper brackets bolt to. (4 of the bolts it comes with are for this, they're a little longer than the stock bolts, but you might be able to get away with the stock ones.) It also uses 2 bolts that go vertically through the frame and hitch at the end of the frame, that's where you will need the 4 steel plates and washers, nuts, etc, because the holes in the frame are much larger than the bolts.