Clutch problems
#1
Clutch problems
97 4runner 5spd 4x4
Some how air is getting into my hydraulic system but im not losing fluid. This happened the other day while driving to work, previously it was working fine
Ill bleed the system and have a nice firm pedal, I will then go for a test drive get a few good shifts then the pedal loses pressure.
I have swapped out master and slave cylinders and have the same problem.
other stuff I have done:
Removed the torsion spring from clutch pedal a couple years ago.
sprayed some high temp grease on clutch fork pivot to stop it from sqeeking
I don't have a clutch pedal return spring on, its been like that for a year, should I put one on?
what should I do next?
Some how air is getting into my hydraulic system but im not losing fluid. This happened the other day while driving to work, previously it was working fine
Ill bleed the system and have a nice firm pedal, I will then go for a test drive get a few good shifts then the pedal loses pressure.
I have swapped out master and slave cylinders and have the same problem.
other stuff I have done:
Removed the torsion spring from clutch pedal a couple years ago.
sprayed some high temp grease on clutch fork pivot to stop it from sqeeking
I don't have a clutch pedal return spring on, its been like that for a year, should I put one on?
what should I do next?
Thread
Thread Starter
Forum
Replies
Last Post
the1998sr5
95.5-2004 Tacomas & 96-2002 4Runners
15
07-14-2020 08:35 PM
the1998sr5
95.5-2004 Tacomas & 96-2002 4Runners
6
07-16-2015 06:20 AM