clutch chatter
08-24-2011, 03:50 PM
#1
Registered User
Thread Starter
Join Date: Apr 2011
Posts: 18
Likes: 0
Received 0 Likes
on
0 Posts
clutch chatter
So after I got the new motor, clutch, flywheel, pp, throw out bearing. I fire the car up and i'm getting some chatter. It is very feint but it seem to happen right next to where the clutch grab. (about an inch or so away from the floor.) So i take the plunge to pull out the trans to see what is going on. I saw that there was a spec of dirt on the flywheel. could this be the cause? i believe s
also I wasn't paying attention when taking off the release bearing. does it matter which way the clip is snapped in?
also I wasn't paying attention when taking off the release bearing. does it matter which way the clip is snapped in?
Thread
Thread Starter
Forum
Replies
Last Post
kawazx636
The Classifieds GraveYard
34
10-06-2021 03:03 PM
primordialbeast117
86-95 Trucks & 4Runners
11
12-19-2015 12:23 PM
smilen724
86-95 Trucks & 4Runners (Build-Up Section)
13
11-08-2015 04:11 PM
hiluxinargentina
86-95 Trucks & 4Runners
0
09-30-2015 11:12 PM
hiluxinargentina
86-95 Trucks & 4Runners
3
09-30-2015 05:51 PM
