Teuf's SAS thread 88 toyota PU 22r-e
04-02-2013, 08:37 AM
#61
Registered User
Thread Starter
Whats wrong with you hubs? A friend at school with an 82 is giving me his clean lubed birfields to instal in my axle. He did a longfield swap so there kinda extra for him. I'll pull apart mine later and clean and lube.
04-02-2013, 05:14 PM
#63
Registered User
Thread Starter
Ya I like pics too, ok knuckles 1 coat, other stuff waiting. I am going to make up a 2nd square drive shaft. Well the first ones not complete.
04-04-2013, 08:55 AM
#69
Registered User
Thread Starter
I'll try and document it as best I can. I often work alone so its a slow go and when my hands are greasy I overlook picking up a camera sometime.
Last night I sandblasted the axle housing, Trimmed my dust shields, blasted the hubs, capped the inner square front driveshaft. We are having a rare hard rain here, I'll take pictures later.
Last night I sandblasted the axle housing, Trimmed my dust shields, blasted the hubs, capped the inner square front driveshaft. We are having a rare hard rain here, I'll take pictures later.
04-05-2013, 02:53 PM
#72
Registered User
I hear ya on that one haha. I don't know how many rags I must've used on just cleaning up my hands to be able to take pictures of my progress for you guys.
04-05-2013, 08:56 PM
#74
Registered User
iTrader: (1)
Join Date: Oct 2011
Location: Tahoe, California
Posts: 987
Likes: 0
Received 0 Likes
on
0 Posts
How much shipped to 96161? Any pics of the mounting holes/spots? I know your truck is lifted but is the cross member essentially in the same spot so it will fit a non lifted truck? Or will it only fit a drop bracket lift...?
Sent from my iPhone using YotaTech
Sent from my iPhone using YotaTech
Last edited by StewsRunner; 04-05-2013 at 09:03 PM.
04-06-2013, 08:37 AM
#76
Registered User
Thread Starter
Ok I will back up, the lift kit is being sold along with the torsion bars and I think the skid plate. If that does not happen I will list the parts being sold. I believe the skid plate mount holes are the same as stock.
04-07-2013, 02:14 PM
#80
Registered User
Thread Starter
A little satin black.......
OK So the next thing to happen this week is the rear third goes on. that I am ok with in regards to the Gl5 gear oil, and the Permatex. / 82194.
Now the axle rebuild. i bought this grease (Valvoline synblend), I will use it in all points, Trunnion bearings, knuckle / bir'f innards and wheel berings. Now????????? should I use (extreme pressure Moly-Graph) in the trunnion bearings? And the syn blend everwhere else....
Veilen Danke
OK So the next thing to happen this week is the rear third goes on. that I am ok with in regards to the Gl5 gear oil, and the Permatex. / 82194.
Now the axle rebuild. i bought this grease (Valvoline synblend), I will use it in all points, Trunnion bearings, knuckle / bir'f innards and wheel berings. Now????????? should I use (extreme pressure Moly-Graph) in the trunnion bearings? And the syn blend everwhere else....
Veilen Danke
