Brake bleeding
#2
Registered User
Join Date: May 2011
Location: Spokane, WA
Posts: 75
Likes: 0
Received 0 Likes
on
0 Posts
Are you sure that the lines are connected to the master cylinder? Haha. But on a serious note, are they all intact and not kinked? Also, make sure they aren't blocked. I would try disconnecting them, and blowing air though. Once when they are closed at the rear and once when they are open. If that works. Maybe the master cylinder is shot and needs to be replaced?
#3
Are you sure that the lines are connected to the master cylinder? Haha. But on a serious note, are they all intact and not kinked? Also, make sure they aren't blocked. I would try disconnecting them, and blowing air though. Once when they are closed at the rear and once when they are open. If that works. Maybe the master cylinder is shot and needs to be replaced?
Thread
Thread Starter
Forum
Replies
Last Post
CanRunner
95.5-2004 Tacomas & 96-2002 4Runners
6
07-20-2015 01:29 PM