jagermeister

I'm in the middle of doing the LC lift in the rear and I'm trying to remove the pan hard bar bolt and I can't get it out. I have the nut off and the other side removed from axle, still nothing. Any tips?

eric-the-red

Hammer. It probably doesn't need much and go easy so you don't mess up the threads.

jagermeister

Ya that was too late. Took an 8 lb sludge to it. Nothing ended up cutting it. Oh well haha

RMA

Dude , I once tried to remove one and I could not get that bolt out , I tried all kinds of hammers, I ended up cutting it off at the bracket.

jagermeister

ya thats what I did, so ill worry about that later. But now I have a new problem, when installing the front bf spacers the CV got pulled out of the inner boot i think and its streched out to far not allowing me to tilt the spindle in to bolt it to the control arm. can I push it back in somehow something?

RMA

Yea . LIne it back up and push it back in.

jagermeister

Ya the boot is hyper extended but we (my friend and I)can't get it back in and its a pain in the ass. Ive changed out one of the half shafts one time ad didn't have this problem any other sugestions?

jagermeister

In school today I was able to press out the old cut in half bolt with the bushing and the outer shell of the bushing. I was wondering if y'all went to Toyota and got a new bolt and bushing ( if you destroyed mine like i did) or if you where about to find one someplace else.