Notices
86-95 Trucks & 4Runners 2nd/3rd gen pickups, and 1st/2nd gen 4Runners with IFS
Sponsored by:
Sponsored by: DashLynx

My runner quit 3.0 after head gasket replace

Thread Tools
 
Search this Thread
 
Old 08-06-2013, 02:18 AM
  #1  
Registered User
Thread Starter
 
skinny's Avatar
 
Join Date: May 2012
Location: Delhi Ontario Canada
Posts: 138
Likes: 0
Received 0 Likes on 0 Posts
My runner quit 3.0 after head gasket replace

Ok did look at it after it did this as had to get to work
But it was piping and snapping
No power
More u touch peddle worse it was limped home

So sat I finished a blown head gasket job
When doing that I did injectors few sensors and plugs and wires
Finished sat it was running good other than bit of rough idle

Pulled boat trailer Monday morn all good used it last night to pull small trailer
About 3 blocks from home cel came on but seemed ok

This morn hop in to go to work
Fired up fine went got coffee
About 15 min running
Starts to loose power and pooping and carrying
On
I limped it home and stole wife's car as its a qualifiying day for work / long weekend

So looking for things to look at when home
Oh noticed the cel was out in dash when this happened
Old 08-06-2013, 09:44 AM
  #2  
Registered User
 
nathan_willetts's Avatar
 
Join Date: Aug 2013
Location: wilmington nc
Posts: 10
Likes: 0
Received 0 Likes on 0 Posts
new distributor maybe and make sure your timing belt is lined up just right take the cover off and line then up to make sure
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
naward1996
86-95 Trucks & 4Runners
25
04-23-2018 05:23 PM
voiddweller
86-95 Trucks & 4Runners (Build-Up Section)
19
05-02-2016 09:10 PM
paxanders
86-95 Trucks & 4Runners (Build-Up Section)
3
06-21-2015 06:29 AM
yamaha73
86-95 Trucks & 4Runners
10
06-18-2015 06:19 PM
Mutinebullfrog
86-95 Trucks & 4Runners
1
06-18-2015 01:36 PM



Quick Reply: My runner quit 3.0 after head gasket replace



All times are GMT -8. The time now is 03:50 PM.