Moog Balljoints problem
#1
Registered User
Thread Starter
Join Date: Aug 2006
Location: Foothill Ranch, CA
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
Moog Balljoints problem
So I am replacing the lower balljoints on my 93 2wd 22re with Moog ball joints and have run into a problem. When I stick the balljoint bolt through the spindle there is not enough thread showing. With the castle nut on tight as can be there is no way to put a cotter pin thorugh. It is almost like it is too short or the castle nut is too big. I don't see how this is possible???! Anybody have any suggestions? Thanks guys!
#2
Registered User
thats weird, maybe you got the wrong part? compaire the new to the old and see whats wrong.
I replaced my LBJs a while ago and i didnt have a prob like that.
I replaced my LBJs a while ago and i didnt have a prob like that.
Thread
Thread Starter
Forum
Replies
Last Post
FS[SouthCent]: TX Third Gen UCA and LCA low miles Taco
KyleT
Axles - Suspensions - Tires - Wheels
1
07-21-2015 07:54 PM
FS[NorAtl]: set of 4 ball joints. any torsion bar ifs 4wd
akaphilly
Axles - Suspensions - Tires - Wheels
0
07-09-2015 02:27 PM