Installing new kick down cable
12-17-2008, 04:15 AM
#1
Registered User
Thread Starter
Join Date: Dec 2008
Location: Columbus Ohio
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
Installing new kick down cable
When removing my A340H out of my 93 4runner with the 3VZ-E motor I lowered the trans without unhooking the kickdown cable from the throttle body. Now it's stretched where it goes into the trans. I unbolted the 10mm bolt but can't seem to get the cable out. Do I need to drop the pan to get to it?
12-17-2008, 05:43 AM
#2
Contributing Member
When removing my A340H out of my 93 4runner with the 3VZ-E motor I lowered the trans without unhooking the kickdown cable from the throttle body. Now it's stretched where it goes into the trans. I unbolted the 10mm bolt but can't seem to get the cable out. Do I need to drop the pan to get to it?
This pic is from a A340F but your's should look similar. You can see the cable end has been removed from the valve body. It helps if you click on the pic and go to the "full size" viewing option in the upper right corner.
Last edited by mt_goat; 12-17-2008 at 08:51 AM.
12-17-2008, 12:26 PM
#3
Registered User
Thread Starter
Join Date: Dec 2008
Location: Columbus Ohio
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
Thanks, my tranny guy spotted it and told me that I screwed the pooch and he was going to put a new one in.
Thread
Thread Starter
Forum
Replies
Last Post
CanRunner
95.5-2004 Tacomas & 96-2002 4Runners
6
07-20-2015 01:29 PM
