Finally installed my stripes.
#1
Contributing Member
Thread Starter
Finally installed my stripes.
The next step is one of the reasons I bought a Toyota, to display my reproduction factory graphics. After the final cut and buff, the stripes went on. I used an 1/8" guideline tape to insure panel alignment of the stripes. This is crucial on this model of 4Runner because none of the body lines line up with each other. I also installed some body side molding for looks and added protection from inconsiderate. I just need to install my Bushwacker flares and put my safari rack back on. I need new wheels and tires of coarse. Sliders, I need sliders too.
Last edited by James Dean; 12-13-2008 at 12:56 PM.
#3
Contributing Member
Thread Starter
#6
Registered User
#7
Contributing Member
Thread Starter
Last edited by James Dean; 12-13-2008 at 12:48 PM.
Trending Topics
#8
Contributing Member
how well does that Isuzu there pull a trailer? mine could harldy pull it own weight, till I bored, camed, port and polished, and bolted a header and Weber 32/36 to it, lmao, then she screamed!
#10
Contributing Member
Thread
Thread Starter
Forum
Replies
Last Post
FS[SouthEast]: Mercury Villager Fan & DCC Fan Controller
coryc85
Misc Stuff (Vehicle Related)
6
09-09-2015 06:24 AM
crashburnoveride
86-95 Trucks & 4Runners
1
07-10-2015 06:39 AM