Coolant Sendor Help Needed
#1
Coolant Sendor Help Needed
Ok, so recently I replaced my coolant sender for the dash gauge, and when I was tightening the new one, the entire area where it bolts into just snapped apart. I didn't know what to do, so I just pushed it in and threw some plumbers putty on top of it and called it good, i have a quart of coolant i have mixed up, just in case the reservoir gets too low. Please help, the guys at Toyota were baffled and didn't know what to do. Please, please help. I need this car to be functioning.
#4
Registered User
Join Date: Sep 2007
Location: San Francisco East Bay
Posts: 8,254
Likes: 0
Received 822 Likes
on
649 Posts
You need to replace the "Outlet, Water Bypass." About $55. http://www.toyotapartsoverstock.com/...rimLevel=18292
Of course, the exact part you need depends on the engine, transmission, drive (the 4wd Auto has another temperature sensor screwed in there, for instance), and to a lesser extent the model year. But now you have the tools to figure it all out.
Of course, the exact part you need depends on the engine, transmission, drive (the 4wd Auto has another temperature sensor screwed in there, for instance), and to a lesser extent the model year. But now you have the tools to figure it all out.
Thread
Thread Starter
Forum
Replies
Last Post
Avenged
95.5-2004 Tacomas & 96-2002 4Runners
4
07-09-2015 07:55 AM
Jnkml
95.5-2004 Tacomas & 96-2002 4Runners
3
07-06-2015 01:20 PM
FS[NorAtl]: 1989 pickup beds and leer cap Rhode island
mickyd9990
Misc Stuff (Vehicle Related)
0
07-06-2015 09:01 AM