clutch install Q?s
#1
Registered User
Thread Starter
clutch install Q?s
allright i got my tranny on the ground and i took out the throw out bearing but it looks like its pressed onto a peice thats connected to the clutch fork...is it pressed or do you guys think i can get it off??
#2
User Requested Ban
Join Date: Sep 2009
Location: Lynnwood, WA
Posts: 1,660
Likes: 0
Received 0 Likes
on
0 Posts
Trending Topics
#9
User Requested Ban
Join Date: Sep 2009
Location: Lynnwood, WA
Posts: 1,660
Likes: 0
Received 0 Likes
on
0 Posts
Yah, napa shows same exact part for 86 tranny ...
You can use a vice or I went to a shop and had them press it off and press the new one on.
BUY IT IN A KIT, my new throw out bearing was smaller because the splines on the pressure plate were smaller.
You can use a vice or I went to a shop and had them press it off and press the new one on.
BUY IT IN A KIT, my new throw out bearing was smaller because the splines on the pressure plate were smaller.
#11
User Requested Ban
Join Date: Sep 2009
Location: Lynnwood, WA
Posts: 1,660
Likes: 0
Received 0 Likes
on
0 Posts
Yah, you have the G tranny or something?
We are pimpin the W's I think ...
i have no idea honestly dude, I just picked this truck up a month ago. and did the entire clutch job over the weekend.
We are pimpin the W's I think ...
i have no idea honestly dude, I just picked this truck up a month ago. and did the entire clutch job over the weekend.
#12
Registered User
Thread Starter
yeah i got the kit, and when i searched that winding whirring buzzing didint quite pop out at me with an answer to my question, none of the results did, but you answered it i need to get somebody to press it off and new one on...figures....thanks
#13
User Requested Ban
Join Date: Sep 2009
Location: Lynnwood, WA
Posts: 1,660
Likes: 0
Received 0 Likes
on
0 Posts
You can do it yourself, if you have a table Vice...
Put the bearing in the vice and use a hammer and a large socket to pop out the housing......
Then place the housing in the vice with the bearing and slowly close it, pressing them together...
Should work like a charm.
Put the bearing in the vice and use a hammer and a large socket to pop out the housing......
Then place the housing in the vice with the bearing and slowly close it, pressing them together...
Should work like a charm.
#20
Contributing Member
iTrader: (3)
You'll have to go to the store, I think this is the one I have and I don't remember that price:
http://www.harborfreight.com/cpi/cta...emnumber=32116
http://www.harborfreight.com/cpi/cta...emnumber=32116