86 Front Diff Q. Help!!
04-28-2008, 12:24 AM
#1
Registered User
Thread Starter
Join Date: Apr 2008
Location: Mesa AZ
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
86 Front Diff Q. Help!!
Hi, I have a 86 ifs pickup and I just installed a lockright in my front diff. I think i did a good job but now that it is in it has a little trouble spinning at a certin point. I can turn it by hand its just a little harder now than before i took it all apart. will it wear in? Did i F up the Bearing? Im super confused.
04-28-2008, 09:36 PM
#3
Registered User
Join Date: Apr 2007
Location: Cascade Mountains, SW-WA
Posts: 252
Likes: 0
Received 0 Likes
on
0 Posts
when two tires are pulling you will no doubt hav a hard time turning. did you research this before you installed it?
did you set the runout, back lash and bearing preload properly?
did you set the runout, back lash and bearing preload properly?
Thread
Thread Starter
Forum
Replies
Last Post
FS[GreatLakes]: Wanted: 4.88 front diff, rear 8'' 4.88
jaretstuff
Axles - Suspensions - Tires - Wheels
1
08-04-2015 02:08 PM
yourrealdad
95.5-2004 Tacomas & 96-2002 4Runners
3
07-29-2015 11:08 AM
Steven.m.paulk
86-95 Trucks & 4Runners (Build-Up Section)
3
07-24-2015 01:44 PM
scottyg486
Offroad Tech
3
07-19-2015 05:34 PM
TokyoD23
95.5-2004 Tacomas & 96-2002 4Runners
4
07-12-2015 06:01 AM
