Have a 82-3 dolphin that has a really bad bucking issue and bogs down when at higher rpms wasn't too bad and was able to drive it for a while with 10% throttle now can't drive it at all without it wanting to buck like a bull and bog down then stall out.
83 Toyota pickup
22r Weber 32/36
Egr delete
New distributor
New fuel pump
New Fuel filterK&N air filter New Fuel regulator set to 2.5 per the Weber manual
Can't figure this out for the life of me idles fine and carb is brand new.

Hi there,

I have a 79 yota with a 20r and way too many problems with the first gen charging system. I noticed that you said you did a gm alternator swap, which I plan on doing. Did you have to modify any brackets? And which alternator did you purchase?

I hope I'm not too much of a bother, I've just put in wayyy too many hours on this and I want to make sure it's done right.

Regards,
Drew

Hi,
Thank you for sharing the FMS for the 83 Toyota. The link you have listed on file share comes up with a webpage that says fileshare services have been closed. If you still have the file, will you share it with me at d.j.parker84@gmail.com

Hey man, I need a couple of mounting brackets for that same bugshield. Any thoughts? I can have some made I guess. I have one. Just looking for the originals if I can find em.

Greetings fellow 1st gener I like your mention of the 140 amp Alternator how did you go about that? Do me a favor and dumb it up a little me and electrical aren't exactly friends.....Thanks

here is my find tell me wich one you want and ill get u a price tomorrow had to rush today
choice #1



choice #2

I take my trucks to Oakland every now and then. I have a friend that opened Oakland ATV and Cycle. I built his 4runner from the ground up and occassionally drive my trucks up to hang out.

Hey man! Good to see a fellow Memphian on Yotatech.

Thanks for checking out my page here is a link to my build of my 83:

https://www.yotatech.com/forums/f197.../#post51897110