taikowaza

Of these two which do you recommend- one is aluminum the other steel. also is the HD pin necessary [IMG] Click for full size - Uploaded with plasq's Skitch[/IMG] Click for full size - Uploaded with plasq's Skitch

This ad is not displayed to registered members. Register your free account today and become a member on Yotatech!

__________________
92 4runner,Thorley Ceramic Headers,Stan's Custom Exhaust,OME Suspension,DowneyHDCoils,MarlinHD Clutch,PIAA520s,24/30"Magnaflow Muf/Cat,Warn Hubs,BudBuilt IFS Skid+Xmbr,Sonoran Truss,Odyssey Batt,33x10.5 BFG A/T,ISR Mod,Boyle's Alternator,TJM T-15,Demello Sliders,Warn XD9000,Dual 4.88 Truetracs,LCE bored TB,Weasy Cams,NWMP Xtnd Range Tank, and most important,Husky Liner WOT Mod :)

4Crawler

Either should work fine, I run an aluminum one on my '85, but that is mainly because I needed to custom fabricate one myself to fit the deep receiver in my rear bumper and AL was easier to machine and since I planned to leave it installed in one of the 3 receiver tubes all the time, I didn't want to worry about it rusting in place:




I run a 7/8" shackle and a regular receiver pin, seems to work just fine.

__________________
1985 Toyota 4Runner SR-5, 22REC engine, dual t-cases, 4.88 gears, dual ARBs, 33x10.50 BFGs or 35x12.50 MTRs
r.c.brown@ieee.org
TruckEditor@tlca.org
Project: 4Crawler
4Crawler OffRoad
Gettin'Off 4WD Club