Where to run wires for safari rack aux lighting?
#1
Registered User
Thread Starter
Join Date: Jan 2004
Location: Anniston, Alabama
Posts: 98
Likes: 0
Received 0 Likes
on
0 Posts
Where to run wires for safari rack aux lighting?
Those of you who have aux lighting on your racks, where do you run the wires and how do you get them into the vehicle?
#2
This is my no drill method.
Check out Jacksonpt's website to see how he ran his in through the rear hatch.
Some drill a hole in their roof below the rack rails, but I did not want to drill any holes.
Check out Jacksonpt's website to see how he ran his in through the rear hatch.
Some drill a hole in their roof below the rack rails, but I did not want to drill any holes.
#5
Also I want to say that some had said long ago when I did this that the wire covering would be scraped off where it goes in through the fender from where it exits the door sill.
Not so.
These lights on the rack have been wired up this way for over three years, and the wires are in perfect shape.
Why drill if you do not have to?
I for one hate leaks, and old man murphy would make sure it leaked on me if I drilled.
Not so.
These lights on the rack have been wired up this way for over three years, and the wires are in perfect shape.
Why drill if you do not have to?
I for one hate leaks, and old man murphy would make sure it leaked on me if I drilled.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
RedRunner_87
95.5-2004 Tacomas & 96-2002 4Runners (Build-Up Section)
84
06-01-2021 01:51 PM