Quick Question About Timing.
11-29-2014, 05:43 AM
#1
Registered User
Thread Starter
Join Date: Nov 2014
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Quick Question About Timing.
Hello Everyone
I'm new to this forum but I hate to just jump in ask a such a big question but I started a my timing belt job on 04 Tacoma 3.4l v6 which i'm sure its a 5VZ-FE. Now my question is I took the belt off before I could set it to TDC and line up the marks :/ am I screwed? or can I still set my timing by turning the cam and crank with out any damage?
Thank you for your time.
I'm new to this forum but I hate to just jump in ask a such a big question but I started a my timing belt job on 04 Tacoma 3.4l v6 which i'm sure its a 5VZ-FE. Now my question is I took the belt off before I could set it to TDC and line up the marks :/ am I screwed? or can I still set my timing by turning the cam and crank with out any damage?
Thank you for your time.
11-29-2014, 09:06 AM
#2
Contributing Member
Join Date: Nov 2010
Location: Columbia River Gorge, Oregon...east side
Posts: 5,125
Likes: 0
Received 2 Likes
on
2 Posts
The 5vz-fe is a non-interference engine. The cam and crank can be aligned to the TDC marks by turning in a clockwise direction with no harm to the engine.
There is a thread in this forum sub-section by member skjos that will go step-by-step through the process on the 5vz-fe.
There is a thread in this forum sub-section by member skjos that will go step-by-step through the process on the 5vz-fe.
Last edited by rworegon; 11-29-2014 at 09:16 AM.
Thread
Thread Starter
Forum
Replies
Last Post
jasonty
Pre 84 Trucks (Build-Up Section)
41
12-23-2018 01:00 PM
icentropy
86-95 Trucks & 4Runners
7
07-14-2015 10:23 AM
