OME Steering Stabilizer
#1
Registered User
Thread Starter
Join Date: May 2003
Location: Santee, CA
Posts: 220
Likes: 0
Received 0 Likes
on
0 Posts
OME Steering Stabilizer
Read the tech article Thank You
Quick Question as per Instructions used BFG to tap in pin to steering linkage BUT There is still A 1/8 inch gap Normal or get a bigger Hammer to Make Flush??
Thanks
Quick Question as per Instructions used BFG to tap in pin to steering linkage BUT There is still A 1/8 inch gap Normal or get a bigger Hammer to Make Flush??
Thanks
#6
Ahhh, at least that makes two of us who had a hell of a time with this thing.
Anyway, just like everyone else said...there should be a little gap there. When I was installing, it all made sense once Cebby posted that picture (thanks again!).
I think a little addition to the write-up in the Tech section may be in order...anyone else? It may save a lot of confusion for people later.
Anyway, just like everyone else said...there should be a little gap there. When I was installing, it all made sense once Cebby posted that picture (thanks again!).
I think a little addition to the write-up in the Tech section may be in order...anyone else? It may save a lot of confusion for people later.
Thread
Thread Starter
Forum
Replies
Last Post
Swampwalker
95.5-2004 Tacomas & 96-2002 4Runners
5
10-12-2015 09:49 AM
justdifferentials
Vendors Build-Ups (Build-Up Section)
0
09-05-2015 06:52 PM