Lining up torque converter with flywheel for bolt install
08-10-2005, 03:42 PM
#1
Registered User
Thread Starter
Join Date: Oct 2002
Location: Big Bear or Tahoe
Posts: 395
Likes: 0
Received 0 Likes
on
0 Posts
Lining up torque converter with flywheel for bolt install
Having a problem lining up the torque converter with the flywheel to install the torque converter bolts. It almost seems like they are turning together. I can't seem to find the holes on the converter itself. Anyone have any tips or tricks they can share with me?
Thanks
Thanks
08-10-2005, 05:25 PM
#2
Registered User
Thread Starter
Join Date: Oct 2002
Location: Big Bear or Tahoe
Posts: 395
Likes: 0
Received 0 Likes
on
0 Posts
I think through search the vast emptiness about toyota transmissions on the internet that the torque converter was not fully seated when the tranny was bolted up. I have to drop the tranny and seat it and then throw up in there again. Sweet. Thanks Mr. Murphy.
08-10-2005, 05:45 PM
#3
Contributing Member
there should be space between the flexplate, and torque converter when the trans is bolted up, sounds like its not engaged all the way into the pump, good luck
08-11-2005, 08:28 PM
#4
Registered User
Thread Starter
Join Date: Oct 2002
Location: Big Bear or Tahoe
Posts: 395
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by superjoe83
there should be space between the flexplate, and torque converter when the trans is bolted up, sounds like its not engaged all the way into the pump, good luck
Thread
Thread Starter
Forum
Replies
Last Post
GreatLakesGuy
The Classifieds GraveYard
8
09-04-2015 09:27 AM
crashburnoveride
86-95 Trucks & 4Runners
1
07-10-2015 06:39 AM
Jnkml
95.5-2004 Tacomas & 96-2002 4Runners
3
07-06-2015 01:20 PM
