Greedy

Just finished putting in my IPT modified Valve body last night and am loving it! Shifts nice and firm and the hideous lag between 1st and 2nd are completley gone. John at IPT was extremely helpful and made the whole process alot easier. One thing though, I snapped a bolt while putting the tranmission pan on... Any Ideas on how to get this fixed? It's not leaking or anything but I am worried about a few years down the road. Thanks!

Praufet

I'd just goto the junkyard and try to to replace the broken bolt. Is the broken part still in there?

TechWrench

I am going to assume you mean one of the pan bolts. If so, you can either try to spin the broken stub out of the casting or drill it out and heli-coil the hole. If the bolt got cross threaded and broke, then the drill and heli-coil method is probably your only choice.