Clutch Master Cylinder help?
#1
Registered User
Thread Starter
Join Date: Oct 2002
Location: bellflower
Posts: 913
Likes: 0
Received 0 Likes
on
0 Posts
Clutch Master Cylinder help?
i replaced my slave clutch cylindera few months back... and i didnt replace the master coz the clutch line that went into the master cylinder wouldnt budge! i tried an open end, channel locks and vise grips. NOTHING! it began to round off so i decided to stop.
ok so i go to autozone today to pickup a flare wrench for the clutch line and i picked up some PB BLASTER. i sprayed the fitting and let it soak in and ate dinner. i come back out to give it a whirl, NO GO! it started to round off again! ack? what to do?
i guess i could cut off the fitting and get a new one and a flare tool and redo it?
any suggestions?
ok so i go to autozone today to pickup a flare wrench for the clutch line and i picked up some PB BLASTER. i sprayed the fitting and let it soak in and ate dinner. i come back out to give it a whirl, NO GO! it started to round off again! ack? what to do?
i guess i could cut off the fitting and get a new one and a flare tool and redo it?
any suggestions?
Thread
Thread Starter
Forum
Replies
Last Post
GreatLakesGuy
The Classifieds GraveYard
8
09-04-2015 09:27 AM
Shaun Crystal Gomban
Pre 84 Trucks
5
07-30-2015 10:13 PM