CBI Rear Bumper put on
#1
Contributing Member
Thread Starter
iTrader: (1)
Join Date: Feb 2007
Location: Central Illinois
Posts: 204
Likes: 0
Received 0 Likes
on
0 Posts
CBI Rear Bumper put on
Great heavy duty bumper for sure. We only had a couple of problems with the bumper but I'm sure they will get worked out with Nathan. He has been very helpful through out the whole process.
I do have a question for others who installed one of these bumpers. Mine didn't come with a rear license plate light (required here). I can tell where the light goes, but not how the wires are supposed to be run.
How did you run your wiring?
Here are a few pics
I do have a question for others who installed one of these bumpers. Mine didn't come with a rear license plate light (required here). I can tell where the light goes, but not how the wires are supposed to be run.
How did you run your wiring?
Here are a few pics
#4
Contributing Member
Thread Starter
iTrader: (1)
Join Date: Feb 2007
Location: Central Illinois
Posts: 204
Likes: 0
Received 0 Likes
on
0 Posts
I wanted a couple of stickers but didn't get any with the bumper. Waiting on Nathan to send me a couple of them.
Loving the bumper so far. Got the highlift on tonight, but still have not had time to finish wiring the plate light yet. Hopefully tomorrow.
Loving the bumper so far. Got the highlift on tonight, but still have not had time to finish wiring the plate light yet. Hopefully tomorrow.
#5
I ran a wire and tapped the running light circuit from the trailer harness, and then just ran a seperate wire to ground out on a bare spot on the swingout. Wrapped it in a loom and zip tied it where needed. I also used a couple deans power pole connectors so i can quickly remove/install the swingout as needed.
Thread
Thread Starter
Forum
Replies
Last Post
Jnkml
95.5-2004 Tacomas & 96-2002 4Runners
3
07-06-2015 01:20 PM
Vargntucson
95.5-2004 Tacomas & 96-2002 4Runners
0
07-04-2015 12:15 PM
dirtrider0129
Buying & Selling Advice - Feeler/Gauging Interest
10
06-24-2015 12:24 PM