CB install on 2002 Taco 5spd.
#1
Registered User
Thread Starter
CB install on 2002 Taco 5spd.
So after searching around a bit, and looking to see what other's did to mount their CB's i found myself stuck. I will eventually move the CB into one of the DIN slots when I replace my 2DIN radio, but for now the stock radio is going to stay.
So I need to figure out where to mount my Uniden PRO538W. the physical dimensions are:
- 8 3/8" (L)
- 6 7/8" (W)
- 2" (H)
I'm thinking about mounting it on the tranny tunnel passenger side and tucking it up as close to the dash as possible, facing the front of the unit up.
If anyone has any suggestions, or better places to mount the thing please let me know.
So I need to figure out where to mount my Uniden PRO538W. the physical dimensions are:
- 8 3/8" (L)
- 6 7/8" (W)
- 2" (H)
I'm thinking about mounting it on the tranny tunnel passenger side and tucking it up as close to the dash as possible, facing the front of the unit up.
If anyone has any suggestions, or better places to mount the thing please let me know.
Last edited by LuminoZ; 08-16-2007 at 04:05 PM.
#3
Contributing Member
Join Date: Feb 2007
Location: Camden, SC
Posts: 75
Likes: 0
Received 0 Likes
on
0 Posts
i'm not quite sure how the taco is set up, but i figure where i did it is general for everyone, i did it below the dash, above my right knee near the steering wheel, it fits good for me there i never hit it and it's not in the way but it's really accessible, i have a uniden also, but i can't remember the # of the model
Thread
Thread Starter
Forum
Replies
Last Post
ripp96
95.5-2004 Tacomas & 96-2002 4Runners
6
07-31-2015 11:14 AM
ripp96
95.5-2004 Tacomas & 96-2002 4Runners
0
07-25-2015 02:32 PM
rushw
General Electrical & Lighting Related Topics
4
07-18-2015 01:46 PM