anybody has BudBuilt skid+bell on your 3rd gen.? mind share some pictures?
#1
Registered User
Thread Starter
Join Date: May 2007
Location: used to be so. cal. now Indy
Posts: 636
Likes: 0
Received 0 Likes
on
0 Posts
anybody has BudBuilt skid+belly on your 3rd gen.? mind share some pictures?
specially if you have 1" diff. drop.
thanks.
thanks.
Last edited by TC4RNR; 05-30-2008 at 01:24 AM.
#6
Registered User
Join Date: Oct 2006
Location: Christiansburg, VA
Posts: 148
Likes: 0
Received 0 Likes
on
0 Posts
#7
Trending Topics
#8
Registered User
Join Date: Oct 2006
Location: Christiansburg, VA
Posts: 148
Likes: 0
Received 0 Likes
on
0 Posts
Not after trimming the front fender, some other small plastic spots, and pounding the pinch weld. I have 97 LC wheels which tend to be in the perfect backspace zone.
#11
Registered User
Join Date: Oct 2006
Location: Christiansburg, VA
Posts: 148
Likes: 0
Received 0 Likes
on
0 Posts
The front skid and belly pan are about 250 each or 450 for the set. Shipping was more reasonable than I thought it would be.
Out of respect for the OP,
#14
Registered User
Thread Starter
Join Date: May 2007
Location: used to be so. cal. now Indy
Posts: 636
Likes: 0
Received 0 Likes
on
0 Posts
is this piece the belly skid?
the guy i bought from did some cutting so i have to patch up with some 3/16" plates. i'm wondering where it goes on to.
the guy i bought from did some cutting so i have to patch up with some 3/16" plates. i'm wondering where it goes on to.
Thread
Thread Starter
Forum
Replies
Last Post
crammit442
95.5-2004 Tacomas & 96-2002 4Runners
7
11-29-2017 12:30 PM
FS[PacSouthWest]: 2- 8"3rd members:4.88 ratchet lockers,new setup kit, rear axle rebuild kit,diff armor
jerusry
Axles - Suspensions - Tires - Wheels
1
10-19-2015 05:28 PM
landrunner
86-95 Trucks & 4Runners
17
08-05-2015 09:18 PM
anniesball
95.5-2004 Tacomas & 96-2002 4Runners
0
07-29-2015 11:46 AM