Any ideas?
#1
Registered User
Thread Starter
Any ideas?
Hey guys, I picked up some aisin hubs a while back and decided to put them on the 4runner today. Got the first one on just fine. Did the same on the second one and as I was bolting the dial cap on one of the bolt heads ripped off. So now I've got part on the bolt stuck in the hub body. Any ideas on how to get it out without damaging the hub body? I tried a tap and it must be in there pretty good because the tap just snapped in half...flust with the rest of the bolt in the hub body. Thanks in advance
#3
Registered User
Thread Starter
I've tried that and the extractor snapped when I tried to back it out. screw extractor is what I meant by the tap earlier.....didn't work..just snapped in half. Thanks for the input though
Thread
Thread Starter
Forum
Replies
Last Post