99 4runner exhaust install?
#1
Registered User
Thread Starter
Join Date: May 2010
Location: westerville, ohio
Posts: 101
Likes: 0
Received 0 Likes
on
0 Posts
99 4runner exhaust install?
alright well i just got my borla catback exhaust yesterday and decided i was going to try and figure out how to install it. well i get under it and see that it has two cats and the bank 2 o2 sensor is right before the last exhaust flange. well there is a 02 bung welded into the new exhaust right after the flange and im trying to figure out what to do here. if anyone has installed one of these before please let me know what to do. i can usually figure out what to do in these kinda situations but i have no clue on this one. didnt think a no hassle install would be like this. thanks in advance
#2
Registered User
Join Date: May 2007
Location: Denver metro area-CO
Posts: 2,175
Likes: 0
Received 2 Likes
on
2 Posts
it sounds like you have a California emission vehicle, So you may not have ordered the right Borla system to fit.
Otherwise it will simply be spliced in after the last oxygen sensor. But have a muffler shop look it over and quote it and see if they could not do a better job for less hassle than you could yourself.
Otherwise it will simply be spliced in after the last oxygen sensor. But have a muffler shop look it over and quote it and see if they could not do a better job for less hassle than you could yourself.
Thread
Thread Starter
Forum
Replies
Last Post
RedRunner_87
95.5-2004 Tacomas & 96-2002 4Runners (Build-Up Section)
84
06-01-2021 01:51 PM
FS[PacSouthWest]: 2- 8"3rd members:4.88 ratchet lockers,new setup kit, rear axle rebuild kit,diff armor
jerusry
Axles - Suspensions - Tires - Wheels
1
10-19-2015 05:28 PM