Please note that the email server is about 1 to 2 hours behind, so please do not create a second account while waiting for your registration letter to arrive
Welcome to Yotatech!
Welcome to Yotatech,
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join our community today!
Materials
4 U bolts (you can get them at Home Depot)(I am not sure of the size, it is the larger one)
2 6*9 speakers, you can use any that you want, i used these
2 6*9 encloses, i used these
Instructions
Step 1: Cut the left corner off of the drivers side speaker box and cut the right corner off of the passenger side speaker box
Step 2: place speaker boxes as shown in picture
Step 3: Mark where holes should be drilled for U Bolts
Step 4: Remove boxes and drill holes for U Bolts
Step 5: Replace Boxes and place U bolts around roll bar and through speaker boxes
Step 6: tighten nuts on U Bolts evenly, tight enough so as the boxes do not move
Step 7: install speakers in Cases
Step 8: hook up wires from old speakers, or run new wires to it
Picture
There is only one, because i did not think about writing this up while doing it/ did not think that it would turn out this good
Notes
-There are no measurements because i didnt measure anything, i just winged it
- If you have any Questions/Comments just PM me
This ad is not displayed to registered members. Register your free account today and become a member on Yotatech!
09-17-2008, 06:24 PM
Similar Threads
