350 swap exhaust ?
#3
#4
Registered User
Join Date: Jun 2006
Location: Ocean Springs, MS
Posts: 262
Likes: 0
Received 0 Likes
on
0 Posts
#6
Here is pics of the ram horn I bought. and where it hits the frame and don't quite line up on the exhaust ports,
Here is advanced $120 more headers picture
And here is a picture of block hugger 350 headers???? which this is a quick picture i found of them they normally look like the adavanced one with the outer tubes on the outside not inside like these ones in this oicture
So this is actually why i am asking before I purchase a set..
Here is advanced $120 more headers picture
And here is a picture of block hugger 350 headers???? which this is a quick picture i found of them they normally look like the adavanced one with the outer tubes on the outside not inside like these ones in this oicture
So this is actually why i am asking before I purchase a set..
Last edited by Jfoust; 03-16-2011 at 02:13 PM.
#7
Registered User
Join Date: Aug 2010
Location: Dayton,NV
Posts: 231
Likes: 0
Received 0 Likes
on
0 Posts
I used the block hugger headers just like the ones in the second picture. By looking at your pictures i think my engine sits a little higher than yours which gives a little more clearance between the frame and block. But be careful with those headers, mine didnt fit quite right ( i bought mine from ebay) and so i had to pound a dent on the inside of the drivers side header by the collector. Thats probably why AA has the outer tubes on the outside. Check out my albums on my profile for some pics of my exhaust.
Trending Topics
#8
Use s10 v8 conversion headers and or northwest Offroad has Toyota to gm specific headers I used the s10 conversion headers and work fine my motor also sits up using the stock Toyota motor mounts
#9
look 1955 chevy v8 exhaust manifolds just cut the alternator mount off the drivers side and reverse the left to right. I also have a set of manifolds off a 1999 silverado 4X4 5.7 vortec engine both sides angle to the rear I haven't tried them yet but the look like they might work. They both exit to the rear at an angle. I am hoping they will work they are much more free flowing exhaust.
Thread
Thread Starter
Forum
Replies
Last Post
GreatLakesGuy
The Classifieds GraveYard
8
09-04-2015 09:27 AM