No oil pressure
09-04-2008, 01:33 PM
#1
Registered User
Thread Starter
Join Date: Jul 2007
Location: Anchorage Alaska
Posts: 58
Likes: 0
Received 0 Likes
on
0 Posts
No oil pressure
Just finished my motor swap with a new 22re, its runs but i have no oil pressure. I replaced the oil pressure sensor. When i turn it on the pressure gauge comes off of the peg but its just below the operating arch. what can i check or change without ripping the motor apart again?
09-04-2008, 01:53 PM
#2
Registered User
Thread Starter
Join Date: Jul 2007
Location: Anchorage Alaska
Posts: 58
Likes: 0
Received 0 Likes
on
0 Posts
its exactly the same as the old engine. It came with a new pump installed by www.sunwestautomotive.com
09-04-2008, 03:04 PM
#5
Registered User
i was talking about a gauge.. see if you can get one then check for oil pressure! that will tell you if its the gauge, or not. eliminate the idea of a faulty gauge.
just my .02
just my .02
09-06-2008, 06:01 PM
#6
Registered User
Use an oil pressure tester and see what your actual oil pressure PSI is
http://www.harborfreight.com/cpi/cta...emnumber=92687
http://www.harborfreight.com/cpi/cta...emnumber=92687
Thread
Thread Starter
Forum
Replies
Last Post
Odin
86-95 Trucks & 4Runners
8
07-15-2015 09:28 PM
88yodabasket
86-95 Trucks & 4Runners
15
07-13-2015 01:32 PM
