renofox

Hey guys. a heads up on my project


There's been a setback. i tested my cell with the glued components so to test HHO production. theres leaks. it's not air tight. i managed to temporarily get it sealed to test the gas with the same 5v cel charger. it did ok, not a huge amount of HHO put off, but enough to light it and have it pop like a fire cracker. with a friend across the street who gave me a 12v DC converter, we tested it again. LOTS of HHO. we lit a couple bubbles thru a bubbler for safety and it was like a gun going off! our ears where ringing from a dime sized bubble. massive compression on the explosions. this is all good. but...

I barely dropped one of my lids and it cracked. I took the other off and flexed it a little to see if i was nuts. it cracked. crap. I'm scrapping this jar design. I am going to move to another design that i found online. this guy has a v6 tacoma & is doing a bang up job with the documentation. I'll following his lead. I'll keep my progress going too. so N@ (next actions)
- build new airtight housing
- construct new core with all this good stainless i have
- back to putting it into the truck.

I think i'm going to mount it in the cabin alond the back, run the HHO gas tube and electricity like one would for an amp, into the engine compartment. I'll have pictures up of the mounting soon.

in case you want to follow my pictures and videos will be here.

http://www.livevideo.com/renfox

If you havn't heard of this or want more info check these links out.

this one is a guy with a tacoma v6. best info out there i have seen
http://www.youtube.com/user/ZeroFossilFuel


http://www.youtube.com/user/Fusion8r
http://www.punchhho.com/videos.php
http://www.youtube.com/watch?v=DWxVJ...eature=related
http://www.youtube.com/watch?v=sg4sO_6ofMA
http://www.youtube.com/user/Rain4Fuel
http://www.youtube.com/watch?v=MMB2VR0087w
http://www.youtube.com/user/energyfromwater

peace,

J