Rear swaybar on 1st gen
07-30-2009, 09:55 AM
#1
Rear swaybar on 1st gen
I recently did a 63" Chevy rear leaf spring swap on my 88 4Runner. Great mod, super flexy and a nice ride on and off road. However, it introduced a significant amount of body roll in corners.
Rather than buy an aftermarket rear swaybar (Addco, etc.) I'd like to try to retrofit a stock rear swaybar from a 2nd gen 4Runner onto it. I figure at worst I'll be looking at fabricating and welding on some some mounting and bushing brackets. Then I'll include some disonnects and retain the compliant ride off-road.
Has anyone looked into this before? Sound possible?
Rather than buy an aftermarket rear swaybar (Addco, etc.) I'd like to try to retrofit a stock rear swaybar from a 2nd gen 4Runner onto it. I figure at worst I'll be looking at fabricating and welding on some some mounting and bushing brackets. Then I'll include some disonnects and retain the compliant ride off-road.
Has anyone looked into this before? Sound possible?
Thread
Thread Starter
Forum
Replies
Last Post
RedRunner_87
95.5-2004 Tacomas & 96-2002 4Runners (Build-Up Section)
84
06-01-2021 01:51 PM
the1998sr5
95.5-2004 Tacomas & 96-2002 4Runners
15
07-14-2020 08:35 PM
FS[SouthEast]: 1st Gen 4Runner Slider Window, Driver Side
coryc85
Misc Stuff (Vehicle Related)
0
07-06-2015 04:07 AM
