power steering, flare cracked?
#1
Registered User
Thread Starter
Join Date: Nov 2011
Location: Kelso, Wa
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
power steering, flare cracked?
for the second time now my power steering pressure line has cracked at the flare on the pump itself, has anyone ran into this, and is there a remedy?
#3
Registered User
Thread Starter
Join Date: Nov 2011
Location: Kelso, Wa
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
first one was the original, second one was from a buddy, but was able to cut and reflare the old one incase this happened again on the trail. the flare itself is craked or between the 17mm nut and pump orifice, could it be from overtightning?
#5
Registered User
iTrader: (1)
What I have seen is the metal just gets old and brittle from the thermal cycling It gets hot from the engine and the fluid running through then it cools down .
Depending on how cold it gets where you are that can be a big temperature cycle repeat over the life of the hose.
It will be a fine line between being to tight and leaking .
It is the flare that seals . It is possible to over tighten and distort the flare then over tighten trying to seal the leak and end up cracking line where a flaw has been created over time but unseen by the naked eye.
Last I bought any new High pressure Hoses I didn`t think they were that expensive.
I hope that helped a little
Depending on how cold it gets where you are that can be a big temperature cycle repeat over the life of the hose.
It will be a fine line between being to tight and leaking .
It is the flare that seals . It is possible to over tighten and distort the flare then over tighten trying to seal the leak and end up cracking line where a flaw has been created over time but unseen by the naked eye.
Last I bought any new High pressure Hoses I didn`t think they were that expensive.
I hope that helped a little
Thread
Thread Starter
Forum
Replies
Last Post