gandude

Hi, First time for a diff. I can't read paint yet. Help? thanks!

1990 V6 Rear 8" new ARB and 4.88 Yukon. .067 shim .006BS 14 in/lb PBPL new bearings.

http://i721.photobucket.com/albums/w...RingPaint2.jpg

http://i721.photobucket.com/albums/w...RingPaint1.jpg

874runnersr5

http://gearinstalls.com/

ZUK

iTrader: (1)

This is the drive side....it's a little shallow.....add .004" to the pinion shim stack and re-paint.

gandude

Hello ZUK,

Thank you for your time!

17 in/lb PBPL, .007 BL, shims now=.070 was .066.

http://i721.photobucket.com/albums/w...ingpaint-B.jpg

http://i721.photobucket.com/albums/w...ingpaint-A.jpg

coryc85

Hey gandude, if you click that little mountain landscape looking button when you post you can actually insert your image right into the thread like Zuk did for you. Some people like me are pretty lazy and don't want to click


So here they are:

gandude

Thanks Cory,

I will do that in the future.

-Glen

ZUK

iTrader: (1)

You probably don't have to....but if you can find a shim that's .002" thicker then you will be on the money. Good job on the clear paint shots

your specs look good too.

gandude

Thanks again ZUK.

I will remove the .010 shim and replace w/.012 later this week. Hope to install diff this W/E. I have the front 7.5 to do yet.

TORTIS

iTrader: (1)

ZUK, and here I thought you were off fishing.

ZUK

iTrader: (1)

It's so hot here that not even the fish are biting.....

gandude

Hi ZUK,

Third try... 15 in/lb PBPL, .072 shim (3x.020's 1x.012) and .006 BL.

ZUK

iTrader: (1)

Nice job. Go with it.