how to break in a new head
#1
how to break in a new head
im getting a brand new head from attarco and was just wondering the correct break-in period or procediure for it. if anyone could help with this id appreciate it
#2
Registered User
The proper brak in procedure for a cam with a NON-roller follower/lifter
is to start the engine and immediately bring it up to 1800-2200 RPM and
run it there for 15-30 minutes (depnending on cam MFGR's
recomendations) this beds the lifters into the face of the cam and ensures
adequate oil supply during the break in procedure. After that it's
rev-city - no further "taking it easy" is necessary. The first 10-15
minutes of the cam's breakin will pretty much determine how long it will
last.
is to start the engine and immediately bring it up to 1800-2200 RPM and
run it there for 15-30 minutes (depnending on cam MFGR's
recomendations) this beds the lifters into the face of the cam and ensures
adequate oil supply during the break in procedure. After that it's
rev-city - no further "taking it easy" is necessary. The first 10-15
minutes of the cam's breakin will pretty much determine how long it will
last.
#3
Registered User
Join Date: May 2008
Location: Prince George, BC
Posts: 144
Likes: 0
Received 0 Likes
on
0 Posts
Probably a good idea to disconnect the coil and turn the motor over for a minute or so to make sure you got oil circulating up there before really running it.
Thread
Thread Starter
Forum
Replies
Last Post
CanRunner
95.5-2004 Tacomas & 96-2002 4Runners
6
07-20-2015 01:29 PM