4runnerlover95

So I am doing the auto to manual swap on my 1995 V6 4runner. I have the automatic pulled and ready to put the manual in. I was installing the throwout/clutch release bearing and the spring that holds the fork in place is a pain in my butt. I have it on (what I think is the right way) but when I push the fork (as if it was the slave cylinder) after about 3 times the spring slides itself off. Any idea? When its all installed is this going to stop? im really frustrated with this so any help would be nice.

wyoming9

iTrader: (1)

Kinda hard to tell if your doing it right without a picture.

But if it falls off it most likely not on correct.

Perhaps someone has one apart to show you the correct way.

4runnerlover95

Sorry I'm new to usin yotatech but here is the link to the other thread with pics https://www.yotatech.com/forums/f120...earing-253387/