87xjmike

Has anyone done it? If so what all was involved? The only reason i'm considering this is because i have both trucks in working order, 91 yota needs a new timing chain guide and i was going to do a head gasket while am at it... which is quite a bit of work. Or i could spend another 10 or so hours and end up with 30more Hp's. The taco is beat to ˟˟˟˟ but the motor is tip top as i've already rebuilt the top end and i might get almost just as much if i parted it out minus the motor.

Stuwy123

iTrader: (1)

It's been done lots. Most folks end up going with the 3rz for that little bit of extra power over the 2rz.
It essentially motor mounts, fuel lines, exhaust routing and wiring. Check out Marlin Crawler forums for more info on the swap.

87xjmike

ok i'll check them out thanks