how to tear into the L52 transmission
#22
Registered User
iTrader: (1)
Hey bud how did you end up getting these bearing out? I'm in the same spot. Need to know what puller to buy without spending a fortune on a bad arse snap on set.
There are some decent videos on youtube for ford top loader 5speeds. the mechanics are the same from what I can tell.
There are some decent videos on youtube for ford top loader 5speeds. the mechanics are the same from what I can tell.
My L45 input shaft fits in my L52, I got a bigger bearing for it and had it pressed on. Not sure about the L42 input shaft, only if it is the same as L45.
#24
Registered User
Thread Starter
Sorry
Sorry I haven't been on here in years. As I remember it wasn't too complicated. But it was more of trying to figure out a puzzle than anything. Just pulling everything apart and laying it in a way that I can put it back in exactly the same. I sold one of my project Toyotas and gave them all the extra parts I had for this transmission about 2 years ago.
Thread
Thread Starter
Forum
Replies
Last Post