dropzone

iTrader: (6)

***1022 11.18.2015 Sold!***

Ok so I am probably gonna regret this but I am selling my 79-85 Sky's off road rear disc brake kit with transfer case e-brake

**See bottom of post for shipping info**
-this stuff weighs a lot, rotors alone are almost 20 lbs each

Includes
-2 vented rotors machined for 79-85(to fit later axles you would need to have the center bore machined out to 4.25")
-2 caliper mounting brackets
-2 toyota to GM banjo fitting brake lines
-2 autozone calipers (kit uses Monte Carlo calipers)
-Disc Pads from Autozone

-1" Bore Master Cylinder (will add picture tomorrow)

Sky's Off Road Transfer case mounted E-Brake kit

I am asking $375 + Shipping (will try to get best price (probably USPS flat rate box, at leaSt 2 large boxes))
This asking price is OBO, feel free to make a decent offer.
The e brake kit alone is $289+ shipping
http://www.sky-manufacturing.com/cgi...y=TOY-TCEB-001
Rear disc brake kit (not including calipers/pads) is $270
http://www.sky-manufacturing.com/cgi...ey=TOY-DBC-001

Location: Beaverton, Oregon
Condition: new, been sitting on a shelf, some light surface rust
Price: $375 obo (+buyer pays shipping)
Payment : US $$, Paypal
Contact: email, PM or respond here

I prefer not to break up the set





Total from Sky's is much more than I am asking

Located additional goodies:
-1" Bore Master Cylinder (NIB) - I believe it is from Trail-gear
-adjustable proportional valve from Front Range Off Road- my receipt says this was $79.99
It has the metric fittings needed to put on a Toyota


This is a smoking deal

Edit:
have been looking at shipping prices for a couple of people
It looks like the cheapest will be in 3 large flat rate boxes through USPS
Total weight is 84 pounds.
A quote I gave some one in California shipped from Beaverton, OR
USPS: $45, 3 large flat boxes
FedEx : $72, 17"*17"*13" box
UPS : $82 17"*17"*13" box

kawazx636

iTrader: (3)

Just going to throw a promotional word in here.... VERY GOOD DEAL HERE GUYS!! I wish that this deal was available when I did my rear end conversion - I spent nearly $700 plus the outrageous shipping from SORD to get these exact same parts! Only thing missing here is a 1" bore master cylinder and a manual load proportioning valve. Very easy to install and I LOVE my setup! Jump on it!

dropzone

iTrader: (6)

Thanks Dave-
Funny that you mention it
I did find a NIB 1" bore master cylinder that I will throw in on the deal..

kawazx636

iTrader: (3)

Just need a manual proportioning valve now folks! LOL

dropzone

iTrader: (6)

Found it Dave:
Added the prop valve from Front Range Off Road and didn't even raise my price

kawazx636

iTrader: (3)

Well this makes it about a $850 kit for less that half the cost!!! Where were you 2 years ago when I was doing my conversion?!

I8URSVT

iTrader: (1)

Very seriously considering this, as i do need new brakes right now as well. Let me check my funds and see where i stand, and ill get back to you.

dropzone

iTrader: (6)

OK sounds good,

have been looking at shipping prices for a couple of people
It looks like the cheapest will be in 3 large flat rate boxes through USPS
Total weight is 84 pounds.
A quote I gave some one in California shipped from Beaverton, OR
USPS: $45, 3 large flat boxes
FedEx : $72, 17"*17"*13" box
UPS : $82 17"*17"*13" box

Sorry Dave...

I8URSVT

iTrader: (1)

My zip is 22039, if you could get a ship quote that would be awesome.

Thanks
James

dropzone

iTrader: (6)

James- with the total weight and you being across the country the best bet is the USPS flat rate in 3 boxes at $45
FedEx is $102

dropzone

iTrader: (6)

***SOLD***

Edit 1022 11.18.2015