deathrunner

OK, I have installed a couple of alrams before, but this one is driving me nuts.

I have everything working, except the ignition cutoff.

It has a relay that is hooked to a socket that is prewired. The two thick lines were used to splice into the starter/ignition wire.

The other pins have an orange wire and a yellow wire that go back to the unit. No problem there.

Here's where I think my problem is. The yellow wire also has anotehr yellow wire coming off of it. The vague instructions say to wire it to ACC (I/O +), I assume this means the accesory on the ignition harness, so I put it there.

The ignition does not get cutoff when I arm the alarm. I can start it no problem. If I remove the relay, the car does not start of course. I tried a relay that I know works and it still would not cut it off.

So, I tried disconnecting the yellow wire form the ACC, didn't seem to make a difference either way.

Any suggestions on what to try or where to hook that yellow wire to?

__________________

Decroded Piece of Crap