YotaTech Forums - View Single Post - 2nd gen trac bar/ panhard bar removal
View Single Post
Old 08-04-2005, 09:31 AM   #3 (permalink)
anthony1
Registered User
 
anthony1's Avatar
 
Join Date: Oct 2003
Location: torrance, CA.
Posts: 976
Send a message via AIM to anthony1 Send a message via Yahoo to anthony1
The driver side one, the bolt is actually part of the axle.
The passenger side one, it's been in tension all this time, so after you loosen it, put the nut back a little so you dont' ruin the thread, then hammer it till it start to back out the back end.
__________________
http://www.angelfire.com/ca6/954runner
GOD's Country Best Seen In A 4 Runner. SAS front: lf,ARB,Ml4",Marlin arms, rear: cable elock,APlinks,OEmu860,35MT/R 5spd, 4:1.
..."But officer, that was not an illegal turn, it was just an undocumented turn."
anthony1 is offline   Reply With Quote