Quote:
Originally Posted by TOYOTA 1
nice vids man..
bob what gear were you using in that mud hole, 1st or 2nd?
@ all.. you should check your junk for loose fasteners before or after going on a run. loosing a front axle is never good  .. i check my junk before every run, mainly the ubolts, steering, d-shafts and tires. every thing else can fall off for all i care |
1st gear 4 low stock case gears I was trying to get into 2nd but my TO bearing or pressure plate is acting up (sticking)
I go though a torque procedure before and after a wheeling trip. U-bolts, steering , drive shaft, starter, motor mounts, tranny mounts, lug nuts, hub studs.
then I go into the fluids top off and check for quality
funny thing is I was telling al about how my front u-bolts where around 30 ft/lbs and after a torque down to a 100 my ride quality was night and day LOL then his POO falls off on the first run.
Good thing he had some spares