YotaTech Forums - View Single Post

tried4x2signN · 07-06-2008, 02:32 PM

finally!!

I'm dying here fellas, my RTE is running great at @30° BTDC runs, idles and drives ok, till you hit her hard(advance), driving around 4k rpms and she cuts back. I believe it's b/c the timing parameters are out.

I seem to be having some problems similar to you

see here: RTE will not idle and left over night seems to start w/ low compression and tick

i could use all the help I can, she's about one foot in the grave. I'm about to donate her for the $5 and sledge all you want, or to MythBusters to see what a vehicle looks like after a tank has run it over....

She has only minor surface rust so I'm gonna H8 to see her go...but she's already cost me in thousands in pain and suffering.

Oh yeah, and I've put tons of REs together but just can't seem to get this one.

all help will be mucho appreciated, THX

EDIT** whoops, I bought a cam gear partly b/c of what I herd here. Did you have to degree your cam? or did you just get it close and nail it?

How does this look?

07-06-2008, 02:32 PM	#23 (permalink)
tried4x2signN Registered User Join Date: Jul 2008 Posts: 1	finally!! I'm dying here fellas, my RTE is running great at @30° BTDC runs, idles and drives ok, till you hit her hard(advance), driving around 4k rpms and she cuts back. I believe it's b/c the timing parameters are out. I seem to be having some problems similar to you see here: RTE will not idle and left over night seems to start w/ low compression and tick i could use all the help I can, she's about one foot in the grave. I'm about to donate her for the $5 and sledge all you want, or to MythBusters to see what a vehicle looks like after a tank has run it over.... She has only minor surface rust so I'm gonna H8 to see her go...but she's already cost me in thousands in pain and suffering. Oh yeah, and I've put tons of REs together but just can't seem to get this one. all help will be mucho appreciated, THX EDIT** whoops, I bought a cam gear partly b/c of what I herd here. Did you have to degree your cam? or did you just get it close and nail it? How does this look? Last edited by tried4x2signN; 07-06-2008 at 02:44 PM.