Quote:
Originally Posted by AxleIke
Looks AMAZING man! Great work!
Question about the fuel tank. What model ford did it come out of? Also, aside from the sending unit, was everything else just bolt and go? All the fuel lines, and return and presssurized EFI crap?
Again, GREAT looking truck.
|
Thanks guys
ill find all the specs on the gas tank on exactly which one it was. It was an earlier ford f150 tank. I originaly bought one and the hole for the sending unit was way to small to fit my fuel pump into. Again ill find what exact years work best for it.
As for lines i ran all new ones when i did my 3.4 swap (same tube size which was bought at summit racing)all are in about the same stock location but longer becuase the sending unbit sits in the very back of the vehicle. I used the stock rollover valve(pressurizing unit) and it fits perfect in the top of the tank(hole was existing for a similar ford piece). I then took its cap trimmed the edges to make a better seal. then used 4 small screws and some gasket sealer to seal it off nice.
(Edit) The tank is an 1985-1996 ford Pickups 19 gallon with rear tank. Runs on froogle for about 100-200 mines made of a plastic material. Also one more note I took the wiring harness and cut it to reuse the toyota plug for the pump. and it will take some rewiring of the ford sending unit to make it work but its real easy to figure out