YotaTech Forums - View Single Post - PCV location/Seafoam treatment on a Lexus?

4Crawler · 02-27-2007, 08:02 AM

Two reasons I chose not to use the PCV hose was #1 it is too short to fit into the can and #2 it would be too hard to control the flow of the Seafoam, since it such a large diameter tube. I even found the small 3mm ID purge line would suck in too much Seafoam at a time unless I regulated the flow.

02-27-2007, 08:02 AM	#7 (permalink)
4Crawler Contributing Member Join Date: Jun 2002 Location: SF Bay Area, CA Posts: 7,828	Two reasons I chose not to use the PCV hose was #1 it is too short to fit into the can and #2 it would be too hard to control the flow of the Seafoam, since it such a large diameter tube. I even found the small 3mm ID purge line would suck in too much Seafoam at a time unless I regulated the flow. __________________ 1985 Toyota 4Runner SR-5, 22REC engine, dual t-cases, 4.88 gears, dual ARBs, 33x10.50 BFGs or 35x12.50 MTRs r.c.brown@ieee.org TruckEditor@tlca.org Project: 4Crawler 4Crawler OffRoad Gettin'Off 4WD Club