If it take 5 minutes or less for this old fart to do it, you young buckaroos can do it in half the time
Step one:
Peel back the tape off of the harness under the hood.
Step two:
Harness with plug on it is in there, pull it out, and it has a little bit of gray tape around it holding it to the bigger wire that was under the tape you peeled back.
Step three:
Take plug and plug it into the horn.
Step four:
Take horn and position on the fender the way you want it.
Take the included bolt and insert into the hole in the fender and do the righty tighty with a 10 mm wrench.
That is all there is to it.
Very easy.
Here is a
2.5 MB WMV video of before and after.
So easy, and it did take less than 5 minutes to install.
Now I can be heard more easily.
Part numbers are in the vid and pictures, but I will post them here too.
Bought these from
TRD Parts 4U
Horn part # 86510-60240
Bolt part # 90080-11545